![]() View and Download Anderson DA2 instruction manual online. I tested the power on the logic board that 'LikeARabbit' suggested and mine was running a consistent 24.3 V on my digital multimeter. The inside are almost the same as I have both and can attest to this. I opened the cinema display as per the instruction from the. Baixar drivers notebook megaware kripton k series. I was having an issue of a very dim to complete shutdown of my Apple LED Cinema Display 27'. Hello All, I did as 'LikeARabbit ' suggested above, and it worked for me. Here is a, the backlight portions of the internals are very similar to your model. Hopefully that gives you something to go on. If the issue persists then the next step would be to replace the LCD panel or logic board, in either order since they are both costly components. If proper voltage is present then you should inspect the LED backlight sync cable, which is attached to the back of the LCD panel, for damage and then reseat it. If no voltage is present then the power supply is likely bad. Diagnosing the failure in this would require you to use a digital multimeter, set to DC, to check for 23.3-25.7 V between the chassis ground and the 24 V test point on the logic board. The backlight with this model is built into the LCD display assembly and draws power, through a separate backlight cable, directly from the device's power supply and depends on the logic board to provide backlight information.
0 Comments
Leave a Reply. |